IO Pull-up vs Pull-down consumption

[Jose Xavier]

What does consume more power, IO pull-up or IO pull-down? Didn't find information about this on the product specification.

[Stefan Birnir Sverrisson]

Hi Jose

According to nRF51822 PS v3.1 section 8.23 pullup and pulldown resistors have a typical value of 13kohm. Therefore, if you have e.g. a button that connects a certain pin to ground when pressed, and the pin is configured as input with pullup, and you have supply power of 3.0 volts for the nRF51, then the current consumption is 3/13k=230uA when the button is pressed.

[Stefan Birnir Sverrisson]

When not pressing the button (i.e. pulling the pin signal low with external circuit), there should be close to no current consumption (<1uA) if the GPIO pin is configured as input. There is only drawn 230uA when the button is pressed. My primary question is: Is this current consumption really of concern? Is your scenario that the button is pressed a lot? For CR2032 coin cell battery with 220mAh energy capacity at 3V, the lifetime is 0.22Ah/0.00023A = 956 hours = 40 days when the button is pressed all the time. For normal use case, I would assume a device button is pressed less than a minute a day, perhaps a few seconds. So is this current consumption of a concern in your case? I suspect that the internal nRF51 pull resistor values were chosen to give adequate pullup/pullldown for most situations, i.e. to overcome disturbance from different environmental factors. Your situation might be different though, but my opinion is sticking to the internal resistors by choosing pullup/pulldown configuration for the GPIO pins would be the safest choice.