BLE_ADC SAADC sampling rate

[faizan12]

Hello!

USing help from this forum i have successfullz transmitted adc value from one pin of AIN# to ble and reasing values successfullz but now i am facing an issue that when iever i change adc sample rat time from 250 to other lower vaalue to increase sample rat like if i write 2 that is 1/2ms will be 500hz but it gives onlz 10 to 15 ereadings it then app gives an error of gatt connection timeout 0x08 .Can someone help me with this how to set sampling rate at 500 or 1000 hz.

Thanks.

[faizan12]

i have changed to same min and max interval as u said and i also changed tineout interval from 4000 to 5000 just to check but it didnt worked.

when i adjust total samples in buffer size from low to high it send bmvapies to some more time but still gives error aftr some seconds.

[Karl Ylvisaker]

faizan12 said:

when i adjust total samples in buffer size from low to high it send bmvapies to some more time but still gives error aftr some seconds.

What do you mean by "bmvapies"?

Did you define DEBUG in your preprocessor defines, like I asked?
Is there any error being generated / returned on the nRF device when the timeout happens, or is there any mention of this in the device log at all?

Best regards,
Karl