Zigbee Door Lock Example Problem

[_maibi]

SDK: nRF5_SDK_for_Thread_and_Zigbee_v4.1.0

I get started with Zigbee Door Lock Example in https://infocenter.nordicsemi.com/topic/sdk_tz_v4.1.0/zigbee_multi_dynamic_door_lock_nus_example.html.

My configuration is like this.

Door Lock Example: examples\multiprotocol\ble_zigbee\ble_zigbee_dynamic_door_lock_nus

Board: PCA10056

Coordinator Example: examples\zigbee\experimental\cli\cli_agent_router

Board: PCA10059

and I setup the coordinator following commands.

and, I execute command to get door lock address following a pic.

But, It can't find the door lock.

I checked RF channel and zigbee data in same channel via sniffer. 

The coordinator obviously send request match_desc data.

But, the door lock just send beacon request not response.

The door lock can be control via bluetooth uart service.

What am I missing in this example?

[Marjeris Romero]

Hi,

Is LED3 on the door lock ON or OFF (indicating that the door lock has been commisioned to the network)? From the screenshots of the sniffer trace you published it doesn't look like the door lock has been commisioned to the coordinator's network. Try doing a --eraseall on the door lock to erase any existing network keys before flashing the example again, and try to commission the door lock again. If you are still struggling you can share the whole sniffer log .pcapng file here to have more information about what it's happening.

Best regards,

Marjeris

[_maibi]

I tried to an example after a --eraseall command. but it is same.

You are right the door lock has not been commisioned to the network.

I attached log json file. I failed to save .pcapng file. When I clicked Stop or Restart to save log file, The Wireshark always close without saving log file. 

testpacket.zip