• State Verified Answer
  • Replies 3 replies
  • Subscribers 74 subscribers
  • Views 924 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 263673
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Power Profile of Serial LTE Modem with MQTT communication

Styve Naoue

Hello NordicSemi and Developpers,

I am working on a project with using the nRF9160 SiP and running a slightly modified version of the Serial LTE Modem sample from the nRF connect SDK. I am using the in-built MQTT library to transmit data (30bytes) to a broker once every minute. The data comes from nRF52840 via uart to the nRF9160. Given that I am often transmit, I need the modem to stay connected with MQTT  keep alive = 3600, so going to long sleep periods is not in question for during the session duration.

Above is the power profile for a complete cycle

  • 1. I power profiled the consumption of the nRF9160 custom board and DK too separately (PPK2) and notice that every MQTT Tx shows peaks with about 12s to 13s duration ? is this normal? Why do the peaks take so long even though the data is received within the first 2 seconds by my broker?

  • 2. After transmission, there are 24 peaks about 86.3mA each spaced 1.3s apart from each other and finally an 18s drop down to 20mA which I assume is idle state, why the 24 peaks? why i the idle current so high? 

  • 3. I ran the same test with the unmodified Serial LTE Modem code and it shows similar results. Could you please verify/confirm that this behaviour is nor with MQTT communication ?

Thanks for you patient and reply in advance.

Best regards,

Styve.N

Parents
  • 0

    Hello

    Thanks for you quick reply, it has been greatly helpful. We do use PSM with TAU=10min and 1 min active time, so the device barely has time to go into PSM that we already TX the next packet. This is ok though, I just tested with longer transmission intervals and saw about 580uA in PSM (maybe idle mode?) with periodic peaks of about 21mA spaced 1.3s apart. This is still too high for PSM but would not matter in our use case. 
    However, for future devs could you please refer me to Serial LTE Modem examples with MQTT in use? 
    Thanks again.
    best regards,

    Styve N. 

Reply
  • 0

    Hello

    Thanks for you quick reply, it has been greatly helpful. We do use PSM with TAU=10min and 1 min active time, so the device barely has time to go into PSM that we already TX the next packet. This is ok though, I just tested with longer transmission intervals and saw about 580uA in PSM (maybe idle mode?) with periodic peaks of about 21mA spaced 1.3s apart. This is still too high for PSM but would not matter in our use case. 
    However, for future devs could you please refer me to Serial LTE Modem examples with MQTT in use? 
    Thanks again.
    best regards,

    Styve N. 

Children
  • +1 in reply to Styve Naoue

    Hello again!

    Good to hear, Styve! Then the behavior of your device makes sense. The spikes in (2) is the device checking the network during "active time". If the serial interface is active about 600µA is expected during PSM, but I'm not sure where the 21mA spikes originate from. However, there is no need to delve into that if it isn't of concern.

    We don't have any complete sample for using the Serial LTE Modem with MQTT, but I believe the documentation should cover it quite well. If anything is unclear, I'm here to help of course!

    Best regards,
    Carl Richard

Related
Terms of service