OTA is successful in the Custom board. But it's not working

[Mr.NCK]

Hi,

I have done buttonless DFU in Custom board using  NRF52832. My code with DFU is working fine in the nrf52832 Development kit. While I am trying in a custom board. My Application zip was uploaded to the Device Successfully. But, after that its keep advertising as "DFUTRAG" only

Please help me with this 

[Sigurd]

Hi,

Try using the debug variant of the bootloader(pca10040_ble_debug), and see if you get any reasons for why it don't jump the application in the terminal.

PS: If you are having issues with the RTT logging, then you might need to set NRF_FPRINTF_FLAG_AUTOMATIC_CR_ON_LF_ENABLED in sdk_config.h to 0

[Mr.NCK]

I have Debug by following the above-mentioned procedure. It's working fine I didn't stick with any breakpoint error. But DFU  I can't able to do. Other than that all other processes are working fine

[Sigurd]

Mr.NCK said:

But DFU  I can't able to do.

 So it's still advertising with "DFUTARG", and stuck in bootloader after the DFU? If yes, could you post the log output shown in the debug terminal here?

[Mr.NCK]

I have tested in other custom boards that were working fine for DFU. But in this specific board is not working

[Sigurd]

Mr.NCK said:

But in this specific board is not working

1) Do you have a LF crystal on this board?

2) Maybe you can try to do a full erase, nrfjprog --eraseall, program the SoftDevice and Bootloader, and then try again?