nRF9160 in Production

[Saleem]

I want to design the chip (nRF9160) on our board.
1- What kind of external debug / flash (SWD) can I use to flash the modem firmware and my app?

2- Is there any suitable method to update the firmware via serial port from nRF9160 in production mode?

3- Is bootloader available for nRF9160?

I look forward to your feedback and support

[Saleem]

Thank you very much for your feedback.

In my use case I want to use the nRF9160 only as a modem (LTE/GPS). I have done some research in your site and the following are clear to me:
A- To flash and debug the nRF9160 externally I need these adapters J-LINK . Hardware connection looks like the picture

B- to communicate with the modem with AT command, I will use UART0 like here interfacing with UART0 

C- flash the bootloader using J-LINK

My question 

1- Which serial interface can I use to update the modem firmware through MCUBoot and mcumgr (without adapters J-LINK)? The same interface UART0 like this 

or anther interface UART1

2-  it is possible to send At-Command with the same serial interface and update firmware (for example UART0)

Best regards 

Saleem

[Carl Richard]

Hi!

Got from a colleague that it's theoretically possible to use the same UART for AT-commands and serial firmware updates we would recommend against it. 

Best regards,
Carl Richard

[Saleem]

Hi Richard, 

Thank you for your quick reply.

I want to update the modem firmware in production (end of line), and I think it will go through uart (I will also test once the board nRF9160 is there).
My last questions:
1- Is there At-Command, to put the nRF9160 in flash mode, so I can update the modem firmware. Or do I have to trigger/reset via GPIO (hardware).

2- Can I use the GPS receiver while the modem (LTE) is connected to the provider network. (GPS receiver and modem at the same time).

Thanks for your support

[Carl Richard]

Hi again. 

Understood. We have recently added support for updating the modem firmware over serial through the SMP protocol which does exactly what you describe.

1. There is no AT-command for this currently, but I believe you can create a custom one using the Serial LTE Modem and the Full DFU api.

2. Concurrent use of LTE and GPS is possible by applying the power saving mechanics PSM or eDRX, which will give the GPS room to operate when the LTE connection is idle. You can read more about this in the Thingy:91 documentation.

Best regards,
Carl Richard