• State Not Answered
  • Replies 5 replies
  • Subscribers 85 subscribers
  • Views 226 views
  • Users 0 members are here
Attachments (1) Download All
Nordic Case Info
  • Case ID: 257709
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

NDK board is unable to power up

Jie Hao

Currently I am facing an issue where the board was not able to power up by itself when a USB is port into it. However, when an external source is connected through the debugger port, the LED on the board lit up, but the board was not detected by computer/laptop. I was wondering is there servicing for it or perhaps a replacement if a warranty is still valid?

Parents
  • 0

    Hi Edwin, 

    I am flashing segger code nordic16 to the DK board so the following switches i have set to in the DK board are:

    SW9 - VDD mode (middle)

    SW6 - DEFAULT (right side)

    SW7 - Def (switch is at the right side)

    SW10 - OFF (towards the left side)

    This is the default settings i believe as i did not move any of the switches when it arrived. It was working well with this configuration for approx 5 months before the DK suddenly was unable to power up.

    Regards,

    Jie Hao

Reply
  • 0

    Hi Edwin, 

    I am flashing segger code nordic16 to the DK board so the following switches i have set to in the DK board are:

    SW9 - VDD mode (middle)

    SW6 - DEFAULT (right side)

    SW7 - Def (switch is at the right side)

    SW10 - OFF (towards the left side)

    This is the default settings i believe as i did not move any of the switches when it arrived. It was working well with this configuration for approx 5 months before the DK suddenly was unable to power up.

    Regards,

    Jie Hao

Children
No Data
Related
Terms of service