I2C initialization on registers level

[Leonid.K.]

Hello,

I work with the ATE using Algocraft WN series programmer.

It has directly access to GPIO registers through SWD interface with WRITE / READ / COMPARE commands.

I already succeed to toggle and read states on GPIO pins.

Now I need to initialize I2C interface and work with external I2C peripheral devices.

How to initialize the I2C interface correctly?

Is there any description of the proper registers write/read sequence?

Thanks in advance.

[Nguyen Hoan Hoang]

you can download the data sheet from https://infocenter.nordicsemi.com/index.jsp.  It contains all the information you need.

[Jørgen Holmefjord]

Hi,

0xBFFFFFFF and 0xFFFFFF7F is not valid values in the PSELSDA/PSELSCL registers. These registers should be set to the GPIO pin number (0x7 and 0x1E in your case), of 0xFFFFFFFF in case the pin is Disconnected:

The address register should also be set before starting the transfer.

I verified that these commands works with nrfjprog:

nrfjprog --memwr 0x40003500 --val 0x00000000
nrfjprog --memwr 0x50000778 --val 0x00000302
nrfjprog --memwr 0x5000071c --val 0x0000060C
nrfjprog --memwr 0x40000528 --val 0x00000009
nrfjprog --memwr 0x4000350c --val 0x1E
nrfjprog --memwr 0x40003508 --val 0x7
nrfjprog --memwr 0x40003524 --val 0x01980000
nrfjprog --memwr 0x40003500 --val 0x00000005
nrfjprog --memwr 0x40003588 --val 0x00000055
nrfjprog --memwr 0x40003008 --val 0x00000001

This generates the following output on the pins:

Best regards,
Jørgen

[Leonid.K.]

Dear Jorgen,

Thanks a lot for your answer.

But it still doesn't work for me.

I did exactly what you mentioned:

But still don't see any activity on SDA, SCL lines.

May be something else need?

Best regards.

Leonid.

[Leonid.K.]

The SCL line goes HIGH, and SDA line remains LOW. 

If I run code specially written for I2C, I see correct lines activities.

[Leonid.K.]

So, on pic 1 shown how it should be,

and here what I have by a first running after working code:

Please pay attention to low SCK level (why?) and NACK with the same slave address.

The repeated run causes to falling LOW the SDA line.