nrf52840 configuration and Antenna design for custom board

[Moghees]

I want to design custom board for nrf52840. I will be using configuration 5 from Reference Circuit nrf52840. I do not want to use NFC can I leave NFC pins not connected. For antenna design can I use the antenna design in nrf52840 DK?

[ketiljo]

Yes

[Moghees]

I am reading product specifications for nrf52840. In section 5.3.8.2 Regulator specifications, REG0 stage. The max current reading of 25 mA are at which voltage level of High voltage mode because high voltage mode can be from 2.5 V to 5.5 V

[ketiljo]

At any voltage level.

[Moghees]

Thanks for the help. I have another question. I was reading about GPIO current specification in product specification document. We can source/sink 15 mA current in GPIOs configured in high drive mode. We can source/sink upto 4 mA from GPIO configured in normal drive mode. If we configure GPIO in high drive mode and source current of 15 mA from it can we source 4 mA from other GPIOs that are configured in low drive mode?
What is total current we can source/sink from all GPIOs?

Regards

[ketiljo]

We recommend that total sink + source is <15mA. This will ensure that the chip can still use do all internal operations (e.g. radio) without reduction in performance. 

​

If you draw less than min IOH,HDH = 6mA, then the output pin voltage will be (if VDD>=2.7V) >VDD-0.4V. And if you draw less than IOL,HDH = 3mA, then the output pin voltage will be (if VDD>=1.7V) >VDD-0.4V. If you draw more than this, then we don't guarantee >VDD-0.4V.