nRF5340 DK LED5 is bright SW9 is on VDD mode and the PC doesn't Detect the board not working

[Dilghas]

Hello,

I have recently received the nrf5340 development kit as part of the Hackster contest.

I followed the webinar and to get started 

1. Connected board via micro USB and turned Power switch to ON position.

2. the LED5 besides the MCU is on.

3. SW6 is in a DEFAULT position. SW9 is VDD power source position. SW10 is in the OFF position. 

4 Downloaded nRF connect for desktop and nRF programmer tool, but the select device stays grey with no device.

How do solve this error.

Measure VDD with GND - 1.73v

[Elfving]

Hi Dilghas! 

Does the "Select Device" drop down menu say "No device available"? 

With the board connected and turned on, could you open a terminal and run "nrfjprog -i"?

Best regards,

Håkon