Running Nordic Open Thread Border Router image on RPI Zero W

[Nikhil Komalan]

Hello,

I am currently creating a product, and i wanted to make it as cost effective as possible. So i was considering using RPi Zero W for Thread Border router setup. I know Nordic only support there devices etc. 

But i would like to know in general, whether i can use Nordic border router image on RPi Zero W ? Have anyone tried this ? Any sort of information or guidance will be useful.

Thanks,

Nikhil Komalan

[Nikhil Komalan]

Hey,

thanks for quick response. I have followed the official docs for setting up open thread border router. They have given done Border Router setup with a RCP device. Will nordic sample examples provided will be compatible with that ?

i have seen there are very few sample examples given in open thread  directory in NCS, while in NRF5 SDK for Thread there are lot more sample examples also examples are available for MQTT communication. But as mentioned in NRF5 SDK doc, to successfully run examples they require a NCP device with border router. 

[Øyvind]

Hi,

Unknown said:

I have followed the official docs for setting up open thread border router. They have given done Border Router setup with a RCP device. Will nordic sample examples provided will be compatible with that ?

What Nordic samples are you referring to? The OpenThread Border Router is still using the same Thread protocol as all Nordic samples, based on the OpenThread stack. 

In nRF5 SDK for Thread and Zigbee v4.1.0, the Thread examples in this SDK are built on top of the OpenThread stack and nRF5 SDK v16.0.0, which you can use to develop your applications.

The nRF Connect SDK provides support for developing Thread applications based on the OpenThread stack. The OpenThread stack is integrated into Zephyr.

I also recommend looking at our webinar on Developing Thread products using nRF Connect SDK.

Kind regards,
Øyvind