Serial pass-through on PCA10059 (nRF58240) dongle

[roaspey]

I am sending data over air from an XBee in transparent mode to an nRF52840 dongle as ZC.

The data is going over the air from the source and destination addresses using a sniffer and

the network is properly joined to by the XBee router

How do I see the serial data coming out on the serial port ?

[ovrebekk]

Hi 

Which Zigbee example are you running on the nRF52840 dongle?

Best regards
Torbjørn

[roaspey]

I am running the stock firmware on PCA10059 (USB Dongle) and activate ZC via the following:

bdb role zc

bdb start

[ovrebekk]

Hi 

I am not sure what you mean regarding "stock firmware". The PCA10059 dongle is not made only for Zigbee, and out of the box it is only delivered with a USB bootloader in order to allow you to flash it with whatever application you want to run on it. 

Can you confirm which SDK example you have flashed into the dongle, and which version of the SDK you are using?

Best regards
Torbjørn

[roaspey]

It has not been programmed with anything. It is simply as it was received and I tell it to be a zc

usin:

bdb role zc

bdb start

The company we are working with said it only has the firmware it is shipped with.

Is there an example you recommend that will allow serial data to pass out onto a terminal

for processing e.g. with python etc.?

[ovrebekk]

Hi 

I assume the dongle responds appropriately to the commands you send in the terminal? 

Are you addressing the data sent directly to the dongle?

Have you tried to ping it to see if there is any response?

I have sent a request to the Zigbee team if there is anything in particular you need to do to print incoming messages to the CLI terminal. 

Do you happen to have an nRF52840DK as well to test with?
It is highly recommended to get a DK if you need to make any changes to the standard examples. 

Best regards
Torbjørn