• State Verified Answer
  • Replies 5 replies
  • Subscribers 86 subscribers
  • Views 1420 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 275157
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52840 DK board not detected.

rrbbkk

Hello Community,

I have nRF52840 board. When I connect board to system it not get detected.

I tested VCC supply it is OK.

COM port is not seen anymore.

I tried to go into bootloader by pressing button-4 + reset but sill not able to go into bootloader.

I replace USB cable but still it not get detected.

Can you please let me know what happened ?

Thank you

Parents
  • 0

    Hey Rrbbkk!

    That is odd. What is the output of "nrfjprog -i"?

    Are you saying it worked before? Do you remember what you were doing then, last time it worked? 

    I replace USB cable but still it not get detected.

    Could you try another USB port as well?

    Best regards,

    Elfving

  • 0 in reply to Elfving

    Hello Elfving,

    I checked with "nrfjprog -i" this command but nothing displayed on terminal.

    Last time it worked, It automatically get detected when I connect USB cable but Suddenly it is not detecting.

    I tried below things but still board not get detected.

    1. Checked VCC supply it is OK.

    2. Changed USB cable.

    3. Tried on different ports.

    4. Tried to go into bootloader by pressing button - 4 + reset but not works. 

    5. Checked "nrfjprog -i" this command but nothing comes on terminal.

    Below are the some test points voltages.

    1. TP11 - GND  : 5V

    2. TP12 - GND : 0V

    3. TP20 - GND : 0V

    4. TP21 - GND : 0V 

    5. TP18 - GND : 0V

    6. TP17 - GND : 0V

    7. TP22 - GND : 0V

    Could you please help me for solving this issue ?

    Thanks. 

Reply
  • 0 in reply to Elfving

    Hello Elfving,

    I checked with "nrfjprog -i" this command but nothing displayed on terminal.

    Last time it worked, It automatically get detected when I connect USB cable but Suddenly it is not detecting.

    I tried below things but still board not get detected.

    1. Checked VCC supply it is OK.

    2. Changed USB cable.

    3. Tried on different ports.

    4. Tried to go into bootloader by pressing button - 4 + reset but not works. 

    5. Checked "nrfjprog -i" this command but nothing comes on terminal.

    Below are the some test points voltages.

    1. TP11 - GND  : 5V

    2. TP12 - GND : 0V

    3. TP20 - GND : 0V

    4. TP21 - GND : 0V 

    5. TP18 - GND : 0V

    6. TP17 - GND : 0V

    7. TP22 - GND : 0V

    Could you please help me for solving this issue ?

    Thanks. 

Children
Related
Terms of service