direction_finding_connectionless_rx crashes if CONFIG_ASSERT=y

[jakkra]

If I enable CONFIG_ASSERT=y this example will crash (or code using the DF APIs)

To reproduce:

- nRF Connect 1.6.1

- In direction_finding_connectionless_rx add CONFIG_ASSERT=y to the prj.conf

- Build direction_finding_connectionless_rx and direction_finding_connectionless_tx

- Flash and run, then you will see the log below on the device running direction_finding_connectionless_rx

Log from the example:

Enable receiving of CTE...
success. CTE receive enabled.
Scan disable...Success.
Waiting for periodic sync lost...
PER_ADV_SYNC[0]: [DEVICE]: 30:A0:F1:E2:87:5D (random), tx_power 127, RSSI -58, CTE AOA, data length 0, data:
ASSERTION FAIL [0] @ WEST_TOPDIR/zephyr/subsys/net/buf.c:800

[Simonr]

Hi

I tried this on my end and did not run into an assertion fail like this. Are you running the RX and TX examle projects on nRF52833 DKs or custom boards? Is the RX device connected to an antenna array or is it just using a single antenna?

Best regards,

Simon

[jakkra]

Tried in a shielded box still crashes for me. ncs 1.6.1 downloaded from toolchain manager.