Building sample "nrf/sample/zigbee/light_bulb" gives compiler error!

[Elevation]

Hello,

I have been using NRF Connect SDK 1.6.1 with Microbit V2 to run some zigbee projects! Now when I should build some new firmwares I upgraded to SDK 1.7.1 and after that the sample gives the error below! 

CMake Error at C:\Dev\Nrf\sdk\v1.7.1\nrf\drivers\mpsl\temp_nrf5\CMakeLists.txt:12 (message):
CONFIG_TEMP_NRF5 and CONFIG_TEMP_NRF5_MPSL have both been enabled, but must
not be used together.

I have driled it down to that it seems to be the clock control needed for Microbit that gives the error! 

CONFIG_CLOCK_CONTROL_NRF_K32SRC_RC=y
CONFIG_CLOCK_CONTROL_NRF_K32SRC_250PPM=y

Any suggestions on how to proceed? An easy way to reproduce this error is to add the above compiler directive to ..\v1.7.1\zephyr\boards\arm\nrf52833dk_nrf52833\nrf52833dk_nrf52833_defconfig and build for that board.

[Simonr]

Hi

Thank you for reporting this issue, we're currently looking into it. We've made an internal ticket on this and I'll keep you updated on any progress. Don't hesitate to provide any more information you might think is useful.

Best regards,

Simon