Hi,
I am running the lpuart sample to connect nrf9160dk <-> nrf52833dk.
The only change in source is added code to print out the data received from RX.
And I enalbe the console log and NRF_SW_LPUART_INT_DRIVEN, here is the proj.conf:
CONFIG_NRF_SW_LPUART=y # CONFIG_USE_SEGGER_RTT=n CONFIG_LOG=y CONFIG_NO_OPTIMIZATIONS=y CONFIG_ASSERT=y # Comment this section for debugging # CONFIG_CONSOLE=n # CONFIG_UART_CONSOLE=n # Uncomment to use lpuart using interrupt driven API CONFIG_NRF_SW_LPUART_INT_DRIVEN=y
When running the sample, everything looks fine on 9160 side.
I can see the char 0xFF sent by uart_poll_out() and {1, 2, 3, 4, 5} sent by uart_fifo_fill().
read 1 bytes - byte 0: ff read 5 bytes - byte 0: 01 - byte 1: 02 - byte 2: 03 - byte 3: 04 - byte 4: 05
But on the 52833 side, the received data is corrupted.
read 1 bytes - byte 0: fe read 2 bytes - byte 0: 20 - byte 1: 80 read 1 bytes - byte 0: ff (... not repeated same data, randomly ...)
I use LA to check the data on the 52833 RX pin, it looks fine. The 9160 did send the correct data.
Any advice is appreciated, thanks.
