• State Not Answered
  • Replies 3 replies
  • Subscribers 88 subscribers
  • Views 591 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 280791
Options

Thingy91 console LTE Monitor viewing lost

Adeel

Hi Team,

I am working with a few Thingy91's. I have noticed an issue in viewing the Thingy91 output on LTE Link monitor for a few Thingy's.

The 1st Thingy connection in the pic below says connected with UART, and I can view its log on the LTE Link monitor console.

The 2nd Thingy connection says MCUBOOT, and I am unable to see its log on the LTE Link monitor.

The code running is the same for both Thingy's and they work, its just I am unable to view the 2nd Thingy's output on the Link monitor console.

Is there a way to get the 2nd one back to functioning like the 1st one (like with a precompiled firmware or so).

Regards,

Adeel.

Parents
  • 0

    Hi,

    It looks like the second Thingy (the one you don't get any logs from) are in boot loader mode. This probably happened because you held SW4 while the Thingy was powered on.

    To exit bootloader mode, simply powering the Thingy off and on again (while you make sure not to press any of the buttons) should be enough.

    Have you tried turning it off and on again?

    Best regards,

    Didrik

Reply
  • 0

    Hi,

    It looks like the second Thingy (the one you don't get any logs from) are in boot loader mode. This probably happened because you held SW4 while the Thingy was powered on.

    To exit bootloader mode, simply powering the Thingy off and on again (while you make sure not to press any of the buttons) should be enough.

    Have you tried turning it off and on again?

    Best regards,

    Didrik

Children
Related