• State Verified Answer
  • Locked Locked
  • Replies 73 replies
  • Subscribers 64 subscribers
  • Views 8431 views
  • Users 0 members are here
Attachments (2) Download All
Nordic Case Info
  • Case ID: 280817
Options
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UART communication using nRH52840

sravich1
  1. I am a newbee to nrf 52840..I saw lot of documents and got confused on where to start ..indly guide me on this
  2. we are trying nrf52840 dev kit as we are using nrf52840 in our custom board
  3. Let me know how can start for UART communciation using this dev Kit
  4. Kindly let me know the procedures
  5. Also if I plan to use custom board for this..let me know how we can program for incoming BLE msg to be sent via UART..

Kindly let me know

Thanks and regards

Ravi chandran

  • 0 in reply to Elfving

    Hello Elfving,

    Thanks for your response. I did have a look into your tutorials..Now I have decided to go with Nrf connect SDK ...also I got some clue on UART link you have shared which I will have a deeper look..just let me know for Nrf connect SDK..I have installed nRF connect to desktop ..is this correct??.

    so the path is use nRF connect then start the basic project ..connect to Zephr libraries use BLE..then configure UART...then do the testing...is this path correct??

    Let me know..sorry trying to understand

    Thanks and regards

    Ravi chandran

  • 0 in reply to sravich1

    Hello,

    Yes that sounds correct!

    Best regards,

    Elfving

  • 0 in reply to Elfving

    Hi Elfving,

    As I went ahead installing VS studio and then try to do the nRF connect extensions...there I was not able to connect to SDK version connect example ..tried to connect to SDK version v1.7.0 and tool chain..but not linking..says invalid tool chain...do not understand why this is happening??

    also tried installing SEGGER embedded from the website..but not getting the icon during the start up after installation..and also cannot been seen in toolchain of nRF connect..let me know how can we go about this before I start :hello world" program ..thanks

    regards

    Ravi

  • 0 in reply to sravich1

    Hi Elfving,

    I think I have a problem in installation itself..SDK connect open tool chain manager where I install connect SDK V7.0 but when I open the VS studio after installation ..in the welcome page I am not able to do nRF connect SDK path and also nRF connect tool chain path ..it says invalid installation..did not understand whee the problem is?? ...Kindly help me out.

    Thanks

    Ravi

  • 0 in reply to sravich1

    Hi Elfving,

    Iam running with windows 7..is this an issue??..I see the same in NCS getting started...how do we avoid this??

    regards

    Ravi

Related