This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Disconnection error code 0x3E

Hi,

I am using SD 120 Ver 2.1.0 and SDK 8. I am getting disconnection with reason 0x3E sometimes. After disconnection even master is scanning, It wont get connected with peer again. How to handle this error?

I am using SD 120 Ver 2.1.0 and SDK 8. I am getting disconnection with reason 0x3E sometimes. After disconnection even master is scanning, It wont get connected with peer again. I Have attached the sniffer log.

error_0x3e.pcapng

Thanks

0 Petter Myhre over 9 years ago

0x3E is BLE_HCI_CONN_FAILED_TO_BE_ESTABLISHED. Actually haven't seen this before. Are you getting this with the disconnect event? What is your peripheral? Could you provide a sniffer trace?
Cancel
Vote Up 0 Vote Down

Cancel
0 Swetika over 9 years ago

Yes, central receive this at disconnect event. Peripheral is S110 V8.0.0 and SDK 8. I have attached the sniffer trace. First two CONNECT_REQ is successful but at third CONNECT_REQ central gets the error.
Cancel
Vote Up 0 Vote Down

Cancel
0 Swetika over 9 years ago

error_0x3e.pcapng
Cancel
Vote Up 0 Vote Down

Cancel
0 jing over 9 years ago

Can it be that you have enabled adv with filter? and the central device address is not one of those included in your whitelist?
Cancel
Vote Up 0 Vote Down

Cancel
0 Swetika over 9 years ago in reply to jing

i am not using whitelist. Bonding is enabled.
Cancel
Vote Up 0 Vote Down

Cancel