Disconnection error code 0x3E

[Swetika]

Hi,

I am using SD 120 Ver 2.1.0 and SDK 8. I am getting disconnection with reason 0x3E sometimes. After disconnection even master is scanning, It wont get connected with peer again. How to handle this error?

I am using SD 120 Ver 2.1.0 and SDK 8. I am getting disconnection with reason 0x3E sometimes. After disconnection even master is scanning, It wont get connected with peer again. I Have attached the sniffer log.

error_0x3e.pcapng

Thanks

[jing]

Can it be that you have enabled adv with filter? and the central device address is not one of those included in your whitelist?

[Swetika]

i am not using whitelist. Bonding is enabled.

[Aymen Rejeb]

Hi Swetika,

Did you found out the disconnection reason? I'm facing the same issue a you!

Thanks

[Ankush]

Hey I am also getting the same error any updates over this

[Aymen Rejeb]

Hi Ankush, For my case, the reason was that the 32KHz clock is not enough accurate.

[Swetika]

May be below link gives you some hint:

e2e.ti.com/.../377682