Hello, in my zephyr application, I have uart1 configured as receive only using uarte at 921600 baud rate. Below is the description node:
I have a device sending a uart packet every 50ms and although I can see the right number of bytes being received, the data itself is corrupted (some bytes are correct but some are not) and I get a framing error thrown by the IRQ for every packet. I scoped the signal and it is very clean. I have also connected a terminal software (minicom) and I was able to receive the expected data while nrf52833 cannot. I do have another uart running on the same SoC (uart0) and that one is working fine but it is running at 115200 baud rate. I am not sure if I have to do anything special due to the high baud rate. I thought the DMA should help and I have allocated a timer for the byte processing. Here are my config statements:
I thought maybe it is a clock issue but my understanding is the system automatically enables the HFCLK. The datasheet mentions a note about the pin drive strength for high baud rate but since I am not transmitting, I don't think this is related to my case. Please let me know if I am missing anything. Thank you.