Nordic Thingy 91 Low power version of Asset tracker v2 now does not send Barometric pressure nor button press data

[iarakis]

Hi,

I followed the procedure described here with Nordic Thingy 91 https://devzone.nordicsemi.com/nordic/nordic-blog/b/blog/posts/nowi-powered-energy-autonomous-nordic-thingy-91-platform

and now it works with low power consumption and sends data to NrfCloud, that is fine.

However, after adding the prj.conf file, now it does not send emvironmental pressure and button press values. How can still receilve those values into NrfCloud, along with temperature and moisture that I already receive?

Regards

[Simonr]

Hi

If you check out the prj.conf file, you can see that a lot of configs has been disabled, like the CONFIG_LED_CONTROL, the serial interface, and a lot of log event configs has been set to "n". You can't expect super low current consumption and being able to get continuous logging information I'm afraid. You'll need to enable the configs you need again if you still want environmental pressure and button press values, etc.

Best regards,

Simon

[iarakis]

Ok, which are the ones I need to get pressure and button press?

[iarakis]

Doesn´t make sense we have to activate LEDs with CONFIG_LED_CONTROL to read pressure sensor and button press value. Does it?

[iarakis]

I managed to configure so that I receive also button presses. But I don´t receive atmosferic pressure. What should I enable to receive pressure data?

[iarakis]

I have another issue. After some time, I receive "connection timeout" in Nordic Cloud platform. How can avoid this timeout issue?