Beacon problem with LED

[nejcokle]

Hello,

I'm using exeprimental dual mode example with my Beacon kit. I ported the example to work with pca2006, but i'm having problems with led. On my mkit, leds work just fine. But on beacons, when i define a led as output, led starts shining. Also commads like set and clear led don't work.

Did anyone experience this problem before?

[Susheel Nuguru]

just tested it, works fine here.

[nejcokle]

Nope, doesn't work for me. I tried again, and changed BLE_STACK_SUPPORT_REQD S130 BOARD_PCA10028 BSP_DEFINES_ONLY SOFTDEVICE_PRESENT NRF51 to BLE_STACK_SUPPORT_REQD S130 BOARD_PCA20006 BSP_DEFINES_ONLY SOFTDEVICE_PRESENT NRF51 and when i use LEDS_CONFIGURE(LEDS_MASK); command, all 3 leds start shining.

[nejcokle]

But these commands work perfectly with blinky example.

[Susheel Nuguru]

I'm sorry not to mention that, i was just testing if the LEDs are working with gpio functions and I used blinky example to test it. I have not tested it with dual mode example. But I do not see why they should not work, unless the example is using those pins for something else.

[nejcokle]

yeah it looks like example is using pins. I can't think of anything else why this shouldn't work. Do you maybe have any idea how i could check that?