Open SEGGER Embedded Studio button is not displayed at installing nRF Connect SDK v1.9.1.

Question

Hello, 
 
 Follow the steps below. 
 nRF Connect for Desktop v3.10.0 -> Toolchain Manager -> OPEN -> Toolchain Manager v0.10.3 -> nRF Connect SDK v1.9.1 -> Install 
 "Open Segger Embeddedstudio" button is not displayed. 
 I also tried SDK v1.9.0, but it was the same. 
 I have taken the following method, but it was not displayed. 
 https://devzone.nordicsemi.com/f/nordic-q-a/85597/how-to-find-the-open-segger-embedded-studio-option-after-installing-ncs-1-9-0 
 
 For the time being, I skipped the button disappearing and ran SEGGER Embedded Studio directly from "emStudio.exe". 
 
 But I cannot create project.

My directories are below. 
 
 The problem of not appearing the button and not being able to create the project does not let me start my development. 
 Is there a solution? I need your help. 
 thank you. 
 
 Yukio Oyama

OYAMA YUKIO · Accepted Answer

Hello Marte-san, 
 
 I can build the sample project with SES and run it on the nRF9160DK board. 
 
 I've tried so many things out of order that I'm not sure which is the right solution. 
 Basically, I followed the manual installation steps, but I feel that manually creating the config file in the West folder and cloning the repository by git command instead of west had a positive effect. 
 https://devzone.nordicsemi.com/f/nordic-q-a/53779/setting-up-nrf-connect-sdk-git-clone-vs-west-init 
 Since it is a manual installation, the Open SES button does not appear in Toolchain Manager, but I can start SES by running "SEGGER Embedded Studio.cmd" in the v1.9.1 folder. 
 I hope the unofficial installation procedure doesn't cause any problems 
 I have reached my initial goal and would like to close the case. 
 
 Thanks for your many advices 
 Best Regards, 
 Yukio Oyama

Open SEGGER Embedded Studio button is not displayed at installing nRF Connect SDK v1.9.1.

Top Replies