Example For Using UART DFU on NRF52832 on both sides of communications

[Pamela Keiles]

Hello,

I am trying to figure out which example is the closest fit for our design. We are using a 2 processor solution in our product, and the firmware for the NRF52832 has to be able to be upgraded via the UART connection to the main processor. I have found some examples here, but usually it's using a PC application or over the air which does not apply to our design. Also, I'm confused abut some of the examples on the side of the NRF52832 in terms of performing the update. There are references to a "full modem" update, but what is meant by modem? This will be a simple direct UART communication update, is this done via the application on the Nordic chip or can it be done via the bootloader directly?

This has to be a common approach, I'm just unsure where to start. Note I am using the latest SDK release 1.9.1.

Thanks for your help.

Regards,

Pam

[Simon]

As Kazi explained, it is not necessary to use the smp/mcumgr protocol. This case might be useful regarding that: devzone.nordicsemi.com/.../update-code-via-uart-instead-of-fota-nrf9160