Problem in connecting phone with thingy53

[Divya_uni_ulm]

Hello everyone,

I am using Thingy53 device, For the first time when I switched on the device, The LED light blinked twice but since after that it is not blinking also, trying to connect my phone with the device by the device is not discoverable on Bluetooth.

It would be very kind if someone can please provide information about the same or please share the link if there is any demo video for the first time connecting a mobile with device.

Regards,

Divya

[Menon]

Hello,

Is this because you have updated the device with Peripheral LBS application. So default Edge impulse name(Thingy53) is not visible any more.
I guess Nordic_LBS is your device(Thingy53).
Go to your programmer app select Edge impulse option and install.In the select device option select Nordic_LBS. Then your device will be programmed with the default firmware

nRF Programmer--> Edge Impulse-->Install-->Nordic_LBS(under select device)

Kind Regards,

Abhijith

[Divya_uni_ulm]

Initially when I updated the firmware I have done that process through the USB and then I updated the firmware for the Peripheral because it was mentioned in the link that I have shared in my earlier replies. so, do you think I should have update my device through USB to update Edge Impulse firmware?

[Menon]

Divya_uni_ulm said:

Initially when I updated the firmware I have done that process through the USB and then I updated the firmware for the Peripheral because it was mentioned in the link that I have shared in my earlier replies. so, do you think I should have update my device through USB to update Edge Impulse firmware?

No both method results in same.