Dear Support,
as suggested I create specific question based on this thread: QSPI EVENT_READY
Could you please confirm that the QSPI peripheral makes polling of QSPI flash Status Register (command 0x05) by HW? I see that just after calling nrf_qspi_task_trigger(NRF_QSPI, NRF_QSPI_TASK_ACTIVATE) the peripheral starts continuous reading of status register. The same happens just after triggering NRF_QSPI_TASK_WRITESTART (just after the actual write).
I miss this information in the datasheet, so could you please confirm this behavior is correct?
Thank you very much.
Jiri