Antenna pattern AoD

[enoop]

I'm using nRF5340 DK for BLE, AoD (Connection). I am also using the TX example from nordic. I can add extra antennas to the ant_patterns[] (up to 17), with no errors. I also changed #define BLE_ANT_PATTERN to 17. But in reality, while connecting to the chip (through the terminal (Linux)), The maximum number I could change is 10. Is there a pre-defined number somewhere else? 

I also changed CONFIG_BT_CTLR_DF_MAX_ANT_SW_PATTERN_LEN to 17, as you mentioned for nrf52833dk_nrf52833.config for My board (nRF5340) [in the child image).

I am using zephyr and west directly on a Linux VM, without the SDK. When the length is longer than 10, it gives me an error that I'm passing too many arguments. 

Could you pls help me with the error? 

Best, 

[Simonr]

Hi

Got an update from our devs: The Kconfig value of BT_CTLR_DC_MAX_ANT_SW_PATTERN_LEN is used by the controller to check that the provided number of antenna IDs is not greater than the value used during building. By default it's 12 as seen below.

config BT_CTLR_DF_MAX_ANT_SW_PATTERN_LEN
    int "Maximum length of antenna switch pattern"
    range 2 38 if SOC_COMPATIBLE_NRF
    range 2 75 if !SOC_COMPATIBLE_NRF
    default 12
    help
      Defines maximum length of antenna switch pattern that controller
      is able to store. For nRF5x-based controllers, the hardware imposes
      the value is within range 2 to 38, where last value is maximum.
      For general use cases Bluetooth Core 5.1 spec. required the value
      to be within range 2 up to 75.

Best regards,

Simon