THREAD: RADIO COPROCESSOR BUILD ERRORS ON nrf512840DK_nrf52840

[jparekh68]

Hi,

Thread RCP Build is giving error as per the attache image. While Matter Lock sample build is successful with one error but the Board is blinking.

Thanks.

Jogen

[Amanda Hsieh]

Hi, 

Do you get any building errors in the "TERMINAL" tab? You could press "Building" of the pop-up window to open the building log in the "TERMINAL" tab. 

I also see those errors when I create a new app from the app template, but those don't impact building the project. You could ignore them.

Regards,
Amanda H. 

[jparekh68]

Hi,

I think I have been able to build and flash RCP (co-processor sample) on nrf52840DK successfully. See the pic below.

Note: Its a DK and not Dongle.

How do I test it on the board that the program has been correctly flashed? Board is practically same(unresponsive) after the flash.

Regards.

Jogen

[Amanda Hsieh]

Hi, 

Sorry for the delay. I have worked on the solution. 

In the NCS2.2.0, please update coprocessor/overlay-logging.conf with this content and build with "-DCONF_FILE=overlay-logging.conf" 

If you get the build error like this

c:\ncs\220_app\coprocessor\src\nrf_802154_radio_wrapper.c:7:10: fatal error: nrf_802154.h: No such file or directory
    7 | #include <nrf_802154.h>
      |          ^~~~~~~~~~~~~~
compilation terminated.

Please add the following content to the CMakeLists.txt

zephyr_library_include_directories(${ZEPHYR_BASE}/../nrfxlib/nrf_802154/driver/include)
zephyr_library_include_directories(${ZEPHYR_BASE}/../nrfxlib/nrf_802154/sl/include)

 

Then it would look like this

After build and flash, and connect with RTT, it would show:

Regards,
Amanda H.

[jparekh68]

Hi Amanda,

Thanks. Output looks like below:

And Board LED is blinking as shown in the video. Hope you too got the same result.

Regards.

Jogen

[Amanda Hsieh]

Hi, 

Seems you don't build with "-DCONF_FILE=overlay-logging.conf" as my first figure. If you do that, the input files would look like this

-Amanda H.

[jparekh68]

Hi,

Please have a look. In "EDIT BUILD CONFIGUARATION" I am getting only 2 options as below:

Not as in your case. 

Thanks and regards.

[Amanda Hsieh]

Hi, 

Try to press "OK" to add the config before clicking "Build Configuration". 

You could also verify the build command in the TERMINAL tab. 

-Amanda H.

[jparekh68]

Hi!

It's done. Thanks. Close the ticket.

Regards.