THREAD: RADIO COPROCESSOR BUILD ERRORS ON nrf512840DK_nrf52840

[jparekh68]

Hi,

Thread RCP Build is giving error as per the attache image. While Matter Lock sample build is successful with one error but the Board is blinking.

Thanks.

Jogen

[Amanda Hsieh]

Hi, 

Do you get any building errors in the "TERMINAL" tab? You could press "Building" of the pop-up window to open the building log in the "TERMINAL" tab. 

I also see those errors when I create a new app from the app template, but those don't impact building the project. You could ignore them.

Regards,
Amanda H. 

[jparekh68]

Hi,

I think I have been able to build and flash RCP (co-processor sample) on nrf52840DK successfully. See the pic below.

Note: Its a DK and not Dongle.

How do I test it on the board that the program has been correctly flashed? Board is practically same(unresponsive) after the flash.

Regards.

Jogen

[jparekh68]

Hi,

Please have a look. In "EDIT BUILD CONFIGUARATION" I am getting only 2 options as below:

Not as in your case. 

Thanks and regards.

[Amanda Hsieh]

Hi, 

Try to press "OK" to add the config before clicking "Build Configuration". 

You could also verify the build command in the TERMINAL tab. 

-Amanda H.

[jparekh68]

Hi!

It's done. Thanks. Close the ticket.

Regards.

[jparekh68]

Hi,

1. Co-processor is successfully running. See image.

2. nRF52840 DK Board flashing.

3. nRF52840 DK Board (RCP) now connected to raspberrypi.

Is this status correct? Board no longer blinks when connected to raspberrypi.

Kindly guide.

JOGEN

[Amanda Hsieh]

I think so. Do you get any error log?

-Amanda H.