NPM1100 LED Connection

[DougMortime]

Hello,

I am using the NPM1100 in my next device and I had an inquiry regarding the LED connections to the CHG and ERR. I intend to use a 3V panel indicator which is plenty bright at 5mA although rated for up to 20mA.

I have already reviewed a question that seemed similar but didn’t quite follow: 

https://devzone.nordicsemi.com/f/nordic-q-a/81433/npm1100---connect-err-and-chg-to-leds-and-host-at-the-same-time

The NPM1100 Product Specification it shows the following:

According to this the CHG and ERR sink 5 mA which for my LED is fine. However, I’m wondering do I need an external resistor? My understanding is that the VSYS is a regulated output of 5V. I did parse the example circuitry and found the following:

Again no external resistor shown, so I assume that the CHG and ERR have the necessary circuitry without the need for another resistor? 

Apologies for the somewhat simple question but I thought it best to make sure before continuing. 

Regards,

DMoretime

[DougMortime]

I should add that I understand that VSYS is regulated to 5V when VBUS is connected otherwise its the VBAT.