• State Not Answered
  • Replies 6 replies
  • Subscribers 90 subscribers
  • Views 1746 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 302388
Options

DTM test, poor sensitivity problem

stars

Hi，

  Our client has about the hardware design of nrf52805. There is a big difference in sensitivity between the boards of the front and back batches of pDTM test, poor sensitivity problematches (PCB is the same batch), and it has been determined that the matching network should be selected according to the recommended value of the chip (device package is 0201).

The first batch was -96dBm.The second batch was -93~-94dBm.And the first batch of sub-boards has been worn out, difficult to cross-test verification，The customer wants to know if there is any data and report on RF test environment and process of nrf52805. These cannot be obtained from the chip manual. If so, please help to provide them.

Best regards,

star

Parents
  • 0

    Hi，

    The problem has been solved. For convenience, the DTM program is embedded into the application(Existing stack) and switched through GPIO port. The sensitivity measured using the DTM program in the SDK is -96dBm.

    There's a quote in the manual,

    Would you like to ask how the protocol stack determines which receiving addr0 to use? Can we configure it? If so, how to configure.

Reply
  • 0

    Hi，

    The problem has been solved. For convenience, the DTM program is embedded into the application(Existing stack) and switched through GPIO port. The sensitivity measured using the DTM program in the SDK is -96dBm.

    There's a quote in the manual,

    Would you like to ask how the protocol stack determines which receiving addr0 to use? Can we configure it? If so, how to configure.

Children
Related
Terms of service