nrf52833 How to set the Border Router？？

[caidehen]

The four official demo cli, client, sever and so on, which demo should I use to do development ah, and how should I modify it, please advise？？

[Simonr]

Hi

Please check out the Thread border router documentation we have here. Typically a border router solution is based on the Network co-processor along with a host side application on something more powerful with a (often Linx based) operative system.

The nRF Connect SDK does not provide a complete Thread Border Router solution. But for development purposes, you can use the OpenThread Border Router (OTBR) released by Google, an open-source Border Router implementation that you can set up either on your PC using Docker or on a Raspberry Pi.

Best regards,

Simon

[caidehen]

HI  

I want to know where to enter the configuration command how to open the input screen and enter the command?

thandks

[caidehen]

• These instructions are so vague that I'm freaking out

• Specific how to open what software where to enter the command, just give a sentence is too bad really hard ah, I really don't want to get the instructions really sometimes say too unclear I install software has never been successful good uncomfortable！！！！！！！！ 
• 

[caidehen]

• After r a long time of research, is this a success as shown below?

However, I opened the nrf thread topology monitor and found that the device could not be found. As shown in the figure below, I was about to crash. Please give me some advice