The slm application for ncs2.3.0 has no log

I compiled the SLM application for NCS2.3.0 and burned them to the 9160 board.

I was given the following information. It seems to print only bootload-related logs, and nothing after that, and the serial port is still capable of sending and receiving commands.

I didn't make any changes to the application

Parents Reply
  • Hi Narvey,

    It figure out there is a known issue with the newly released NCSv2.3.0. Known issues — nRF Connect SDK 2.3.99 documentation (nordicsemi.com)

    NCSDK-20047: SLM logging over RTT is not available

    There is a conflict with MCUboot RTT logging. In order to save power, SLM configures MCUboot to use RTT instead of UART for logging. SLM itself uses RTT for logging as well. With a recent change, MCUboot exclusively takes control of the RTT logging, which causes the conflict.

    Workaround: Remove CONFIG_USE_SEGGER_RTT=y and CONFIG_RTT_CONSOLE=y from child_imagemcuboot.conf.

    There is a workaround that can be used to switch back to app log output now, we will continue to work on the solution to make mcuboot and app images both work with RTT log output.

    Best regards,

    Charlie 

Children
No Data
Related