Vendor Model packet loss in Mesh

I am using two devices, both equipped with the nRF52832 chip, to send and receive messages through the Vendor Model. One device sends a custom 6-byte data packet every 50ms, for a total of 10 transmissions, which is equivalent to sending 10 packets in 500ms. The other device is responsible for receiving the data. However, the received data rarely includes all 10 packets; it is usually 9 packets, 8 packets, or 7 packets.Then, I sent two custom 6-byte data packets every 50ms, for a total of 10 transmissions, which is equivalent to sending 20 packets within 500ms. However, the received data is usually 14 packets, 18 packets, or 16 packets, and the packet loss rate is still quite high.Is there any method to solve the issue of high packet loss rate?

Parents
  • Hi spring.liu,

    We will need more details about the experiment setup to tell what is going wrong here.

    Could you please share some more details?

    1. What is the setup of the mesh network?
      1. How many nodes are there?
      2. How are the nodes physically positioned from each other?
      3. How many nodes have the Relay feature on?
    2. What is being lost? Is it only the first or last packets?
    3. Does the loss happen with all nodes or only some particular nodes?
    4. What are the values of these network/node configurations?
      1. TTL
      2. Network Transmit Count and Interval
      3. Relay Retransmit Count and Interval
      4. Segment retransmission configurations
      5. If you use periodic publishing, Publish Period, Publication Interval and Publication Retransmission

    Hieu

    P.s: Sorry for the late reply. I wrote it but then failed to send it for some reason Disappointed

  • 1a. There are a total of two devices.

    1b. The distance between them is 5cm.

    1c. Both devices have enabled relay functionality.

    1. A few packets out of 10 have been lost.

    2. This occurs on all nodes.

    3. The devices are subscribed to the 0xC000 group, and they send messages to the group address 0xC000. They send a custom 6-byte fixed data packet every 50ms using access_model_publish for publishing.

Reply
  • 1a. There are a total of two devices.

    1b. The distance between them is 5cm.

    1c. Both devices have enabled relay functionality.

    1. A few packets out of 10 have been lost.

    2. This occurs on all nodes.

    3. The devices are subscribed to the 0xC000 group, and they send messages to the group address 0xC000. They send a custom 6-byte fixed data packet every 50ms using access_model_publish for publishing.

Children
Related