Hi
We are developing software for the nRF51 with Keil under VirtualBox. Previously we used the PCA10000 dongle with the Master Emulator and MCP without issue. Now, with...
We are using nRF51822 for our products.
We want to know the min value of "Receiver sensitivity" when we use this chip for BLE.
The Datasheet says "Receiver sensitivity...
Dear
The BLE Multi-link example (ble_app_multilink_central and ble_app_multilink_peripheral)
shows how one central device can connect to multiple peripheral devices. ...
In the MCP app, if I have the following service data for an Eddystone beacon:
0x10, // Eddystone-URL type
0x00, // TX power in dBm. This is a signed integer so 0xEE ...
I have the nRF Control Panel Android application. It works fine with several BLE devices, but specifically for the Fitbit Flex, it fails to connect.
I know Fitbit wristbandes...
Hi,
The situation:
I was able to successfully receive known packets from a device running gzp_device_dynamic_pairing, from, the host running the gzp_host_dynamic_pairing...
Hi everyone
nrf51822,softdevice s130 2.0.0
now i used softdevice s130 establish two connection as a central with two s110 peripheral device,at the same time i establish...
hi team, i want to edit my uuid, major and minor. i searching for the example. i am using nrf52840. i didnt get any example. but there is a example for nrf51 ble_app_beacon_bcs...
infocenter.nordicsemi.com/.../nwp_015.pdf
Above refered white paper says:
"refer to the Nordic Semiconductor white paper ‘nRF TX measurements’ for procedures on how to...
Is it possible to set two nRF52 as duplex MODEM?
The objective is to monitor a remote solar powered device from a PC. There would be one nRF52 device at each end (one at...
Does anyone know of any nRF52832 devices designed for use as a key fob?
The Thingy52 looks great but it's a little big and I don't need all of those sensors. Also, I'd...
Hello Everyone,
I am trying to run examples of BLE Pheripheral in my NRF51822 board but something is wrong. SoftDevice and algorithm are downloading well but bluetooth is...
I'm trying to port Thingy52 firmware project from Keil to SES.
I followed this guide Segger Embedded Studio - A Cross Platform IDE
I manage to build without any errors...
Hi Guys,
I am new to the nrf52 family of chipsets and started my work with a custom board containing the nrf52832 chip and some on board peripherals like GPS and some sensors...
phenomenon:
When master successfully encrypts using previous binding information, pm_evt_handler in main.c receives a PM_EVT_CONN_SEC_SUCCEEDED event and gets a bonded...
I want to read and write certain pages from the NRF52 flash via nrfjprog. The goal is to debug an issue with the peer manager by saving the FDS flash contents to disk. I would...
I have downloaded the Eddystone example to my nRF52832 dev-kit and I am trying to register it with the google beacon platform using their beacons Tools app but it says that...
Hi,
i have the below queries:
In our project we are using multiple masters and multiple slaves, in that each slave is dedicated to a single master.
for ex: we are having...
Hello. I created some HID device based ble_app_hrs_pairing_nfc example on NRF52. And I have a questions:
1.I need to automatically reconnect to bonded device after reboot...
By default, the NRF_DEBUG is disabled. After enabling, and removing this assert check:
devzone.nordicsemi.com/.../
I am now hitting another one here:
#if ( configUSE_TICKLESS_IDLE...
