Hi,
I assume this would apply to most new boards - but I am finding that the build time since upgrading to newer hardware has increased significantly. Perhaps due to sysbuild...
I am currently using ncs 2.9.0 on a custom board using the internal ldo and internal clock settings. It is a simple project where I take and indicate an adc and internal temperature...
Hi! I am designing a nRF54 based motion tracker that has an IMU onboard which can take an external clock signal for improved timing accuracy. Initially I had thought of just...
Hello I have a custom board with the following dts My zephyr app crashes in bt_enable() Note that uart0 TX pin 8 is used by gps_vrtc_en but uart0 is not defined. Same crash...
Dear All,
I updated Toolchain and SDKs to last version v3.0.2 and I'm going to add build configuration as suggested here How to create and build an application .
My board...
Hi, I have created my own hardware with nRF54L15 – 2xLED, 2xPWM, and Radio (BLE). I am trying to create a custom board using the graphical wizard. LED and PWM seems to work...
Hi! It seems that I may have uploaded a non-working application to the Thingy91x. Therefore Device is not conectable via USB. The device is responding only in "MCUBOOT" mode...
Hello,
I am using the nRF9160 Dev. Kit and I am getting the following error by trying to load any samples.
Loading solution asset_tracker.emProject Executing load...
Hi,
we are using nRF9160 for our application. we are testing the connectivity(NB1) and noticed that sometimes we are getting response as '0' for registration status and...
Hi
I have some doubts and I wanted to know if you could clarify me.
When we are testing the samples provided by you guys, like asset_tracker, mqtt_simple etc, we are programming...
After provisioning a node, I see that the Company field is displayed as "Ericsson Technology Licensing", indicating that the CID field on Composition Data Page 0 equals 0x0000...
Once connected via a reliable USB cable to a computer, nRF52840 DK (Rigado BMD-340 evaluation kit) does not show up as a new device, both on Windows 10 and MAC OS Mojave
Hey all,
I am working on the BLE Buttonless DFU Template and I have managed to add the Serial library in Polling mode.
However I am experiencing issues when reading from...
Hello,
Hello,
I am using nRF52840, SDK_16.0.0, S140 SoftDevice and Segger 4.16 for flashing the image.
I have issues in compiling Secure bootloader with my Public...
SDK 15.2.0 & Mesh SDK:3.2.0 I tested blink DFU code and it is working well. but when I integrate DFU in my code, then fw_updated_event_is_for_me() beacomes true and logs Requesting...
I am trying to create a custom application where I'd like to query the PPK for current consumption values. Is there any documentation describing the bytes the PPK expects...
Hi,
I am evaluating nrf52840 using the light switch example.
Environment:
Soft device : s132_nrf52_6.1.1
Mesh SDK Version: 3.2.0
SDK Version: 15.3.0
IDE: SES ...
Hello!
I currently want to save the sensor data obtained by SPI communication to the microSDHC card by SPI communication.
Writing to the SDHC card is possible without...
To the kind attention of Nordic support team,
I'd like to open a new thread after the first one ( https://devzone.nordicsemi.com/f/nordic-q-a/46318/configuration-of-gzp_dynamic_pairing...
