Hi,
I am trying to set up a project that continuously measures the pulse width of a signal that may or may not be present at a pin.
I want to use a Timer in capture...
hi
after success dfu operation the firmware start to run
then i am getting stuck write after err_code = sd_ble_gap_device_name_set(&sec_mode, new_name, DYNAMIC_NAME_LEN...
I've been following the information on the nRF54H20 with interest as it is most likely the natural candidate for upgrading our existing design. However, I have been waiting...
We are developing an application on nrf52840 and wanted to use M95P32 as external flash.
used below .overlay configuration to enable it on zephyr.
&mx25r64 {
compatible...
Hi,
Using nRF Connect SDK 2.7.0 on an nRF9160. Using native tls, works fine, i can setup HTTPS connections.
Problems arise when i try to use MQTT with native TLS (with...
Hello Nordic DevZone community,
I have been working with the ZBOSS stack on the nRF5340 and understand that it has version management and migration features for persistent...
SDK 2.3.0
We have a custom board with a few GPIO connected to various interrupt sources (Button, sensor interrupts, power connection etc.)
We are experiencing here sleep...
Hi,
I've been modifying this example in order to make some things automatic, which include to read some characteristics via BLE. So I'm trying to use this read function...
I wish to automate the nRF connect tool using python, e.g. perform a scan, connect to a device, discover the services and write some data. Is this possible? I have stumbled...
Hi
facing a strange issue in my firmware.
I am deleting the bonds in the initialisation.
When I go for a hard reset, sometimes I get the peer id list NULL --> correct...
Hi,
I am experimenting with the Thingy52, how do I transmit data from it to the cloud platform of my choice?
In the menu options, I see cloud, what is it for?
What...
Hi,
AFAIK, the peripherals on the nRF52832 need to be explicitly enabled. If that is the case, what would be the current consumption of the chip if I program it using the...
Dear sir,
I use nRF52832 for our product. But I change PCB antenna to chip antenna, modify match circuit. At this conditions, which bluetooth SIG certification process should...
Hello everybody ! Designing with the development board nRF52832 and SDK14.2.
My code is based on the code of the "ble_app_multilink_central" on which, I added some of the...
Hello, nordic.
I have added uart functionality to hrs example, to add OBB pairing to uart example.
I have replaced as hrs --> nus and have inserted uart_init(), uart_event_handler...
I want to connect esp32 with nrf52840 for availing Bluetooth 5 functionality. In this, I want to use esp32 as application processor and nrf52840 as network co-processor. Is...
Hi everyone,
We develop the project on chip NRF52832 with SDK v14.0.
The chip in this project works in multirole mode. During the work it must scan the devices to acquire...
In order to transmit sensor readout from an I2C sensor I have to write new software for the nRF51822 to use the I2C bus and need to change the Android app for displaying the...
I've read, that a provisioner/client in an application like the lightswitch example can only manage up to 50 nodes (servers), using persistent storage on a nRF52840 device...
Hello Recently, after a long time not using my Thingy52, I encountered a problem with it. I cannot connect to the device. Earlier it worked fine (can't remember if it was...
