Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hello,
We are developing a system in which a device controls a host and the device should receive status information about the host. In some use cases multiple hosts are...
Hello everybody !
I am looking to connect 2 cards nRF52 DK (52832) with another card nRF52 DK (52832), a little like the fact my smartphone with these 2 development cards...
Hi, all.
I'm making a mqtt client with nRF52832.
All examples of SDK 14.2 were using PSK secure.
But I want more secured connection as like MBEDTLS_TLS_RSA_WITH_AES_256_CBC_SHA...
Hi,
After sd_ble_gatts_hvx() call, is it possible to change or delete value in softdevice buffer before a connection event ?
Thanks by advance for your help
Best regards...
We have a medical products need to evaluate the maxinum transmission data rate of BLE .i am using is the latest nRF5_SDK_15.0.0_a53641a.
i find to using the ios lightbule...
Dear Developers,
Good Day!!
I want to merge ble_app_att_mtu_throughput & uart example, basically requirement is CLI & other UART communication should work together.
...
See a new landing page on the nordic website for the nRF52840-DK (as opposed to PDK), which states that..
"The nRF52840 replaces the nRF52840 PDK which is not recommended...
We are fine tuning our manufacturing process placing the nRF52840 and would like to know what surface finish is used on the chip. I was not able to find this in the spec.
It seems like a similar IAR debugging problem has been solved but after a day of trying everything...
BLE application with SDK 6.1 and SD 310 1.0 running IAR 8.1 (and identical...
Hi!
Thank you for providing an SDK for BT mesh so early. I'm wondering if you also provide an Android (or perhaps iOS) mobile app that interacts with BT mesh, e.g. by acting...
Hello,
i'm a french student so i'll try to do my best to talk in english with you. I'm trying to use and understand the nRF51822 in order to transmit data to a smartphone...
Hi Expert,
why BLE_APP_UART example can use button 1 to button 4 to wakeup from sleep?
I checked source code I only saw the BTN_ID_WAKEUP is 0.
#define BTN_ID_WAKEUP...
Hi, according to the Bluetooth Mesh Glossary , there are 4 features supported:
1. Relay;
2. Proxy (GATT);
3. Low power;
4. Friend.
Questions:
- Which of these...
