Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Hi, my friend,
I've been with nrf905. I use a 16-bit CRC check.
But I encountered problems in use:
1.Nrf905 16-bit CRC check format is CRC-16(IBM):X16+X15+X2+1 or other...
Hello,
We're looking for easy way to communicate between nRF51822 configured as central part with C# application.
Ideally we should use standard firmware which forwards...
Hi,
Im trying to monitor the high voltage im generating with PWN using ADC. I also need to run BLE at the same time to provide results.
So far I dont have any luck and...
Hi,
Why you use a Hex format file for the firmware with a Toolbox Android, then the IOS Loader you use a binary format file ?
Because I would like use the same file. ...
I have a nRF51822 and arduino uno board. Is it possible to connect my nRF51822 uart to the arduino rx/tx, so that i can use it for communication to PC through arduino. The...
I'm having some problems when flashing the mbed enabled nRF51 kit. This is currently my environment:
When I try to download the file I always get this error: "Cannot Load...
Hello all,
I have two services which has characteristics with indication only property. I am using sensor simulator to generate values. When i write first CCCD write of one...
Hello,
I have been searching for GPIO documentation, particularly on interrupt configuration, and I have come up short. Can someone send me a link where I can find more...
As we know, there is a solution of wireless charging in nordic. I just want to know where is the Bluetooth stack in the solution? In SOC or in Bluetooth controller? If In...
Hello,
I am using nordic development kit nrf51822 and i was trying some examples of it as given. But in that in one example there is one function
static void gpiote_init...
I am aware that the debugging interface draws significant current, I do not believe that is the case.
I have 2 designs in front of me. Let's call them '2.0' and '3.3' ...
Hi
I'm a little confused with the RAM usage with S110 support, the following represents the memory usage of example of "ble_app_template", even there is no any application...
Hi,
i want to know
how to sink mobile and softdevice in BLE or WIRELESS(having 4.0 stndrd)?
how to send BCON from nrf51288 board in order to set connection with...
Hello,
We have started down the path of getting our first Bluetooth Smart product through the Bluetooth qualification process. We are using the nRF51822 with SDS 6.0.0...
