Hi
I have two DKs, previously they work well, however, after I add the nRF21540 FEM on each DK, I always receive this in my central device:
Whether the amplifier cause...
Hi, I am currently trying to get through the NRF connect SDK fundamentals, I am on lesson 3 example 1, creating an application. The problem I am running into is that I cannot...
Background - We are laying out a new board, upgrading to the nRF54, and wanted to use p2.02 and p2.03 as serial UART lines because p1.04 and p1.05 were planned to be used...
Hello,
I face a problem which I can't understand really and where I need support.
It is strange...
In our electronics we use the nRF52840 which is enclosed in a module...
Hi there,
I have recently upgraded my software to latest ncs 3.2.0. I have noticed that my initialisation does complete but it ends up with fatal error that seems to be...
Dear Nordic,
I am debugging a custom hardware with a nRF7002 on-board, using wifi shell app. At this moment the shell does not work as expected, needs to locate where the...
I am attempting to install nRF Connect SDK along with VS Code on an offline machine for development. The main two issues I have are:
The NRF Connect for VS Code plugin...
In Short: How to get status wether noticiations are enabled or not? Where is this stored?
Hello,
I would like my peripheral to start/stop a timer that does measurements...
I have a project which will send the temperature from the nRF51DK to host.
The value of the temperature is an integer. As example Value:0x00000A2B -> 2603 ->26.03°C
...
NRF24L01 has its own protocol, but I do not understand the protocol itself is how to handle the payload sent and appear in the header contains the same Bite, whether to adopt...
I'm implmenting my own radio porotcol and I'm a little confuse on how to handle the ACK packet. I send a packet from node 1 and disable the TX then I enable the RX to get...
I'm unable to pair my device with Windows 8.1.
Pairing with Android works just fine whereas when I try to do it on my computer it just tells me that the device is no longer...
Hi,
I don't know if it is the appropriate place to ask my question.
One of our J-link lite cortexM debuggers is broken. We want to buy a new one. But, we realized that the...
I'm using the 8.0 SDK and an iPad with iOS8.3. I'm experiencing the same issue described here:
pairing cancel cause reset
I've written my own service, however, I can...
Hello,
I noticed the various examples as well as the ble_advertising component all check for pending flash operations and will not start advertising until they are all...
Hi,
I am busy writing my own softdevice, this has nothing to do with bleutooth or anything like this.
In the past i didn't have to worry about the CLENR0 register because...
Hi everybody,
I have a mistake with my makefile on windows 7 platform and Eclipse C edition.
The error is quite rapid =>
20:42:38 **** Build of configuration Default...
Hello devzone...
My setup: nRF51422 and S110 peripheral
My setup transmits IR data on reception of Bluetooth data from a central device. I have used PWM for generating IR...
Does the nRF51422 ANT Inclusion/Exclusion list require all values in the list to be defined, or may some of them be '0' or 'wildcard' values?
Asked in another way, does...