Hi,
I’m working on a Matter application using the nRF Connect SDK v2.9.2 . I’ve added the AirQuality cluster into my device with sub-sensors: CO₂, PM1, PM10, TVOC, and Temperature...
nrf5340DK
NCS 3.0.0
if I use sample zephyr/samples/boards/nordic/system_off it works fine and i can wake from sw0 press. but if i move the sys_poweroff() call int a...
Hi Team,
Recently we did a network related testing for our CL5G modem (nrf9160) and observed a problem, in this test we used a nmap tool, this tool will search for open...
Steps to reproduce the problem
Create a new application based on the Matter Light Switch example of the SDK 3.0.2
In prj.conf set CONFIG_CHIP_FACTORY_DATA_BUILD=n
...
I would like to do a FOTA using bluetooth and external flash memory on nrf52840 board. I am also using sdk 2.9.1 The issue i am currently facing is I get the below when i...
Hello nordic community,
i have custom board that have nRF5340 and nRF7002, our requirement is to use wifi every 5 minutes (connect send data and disconnect) but randomly...
I have the nrf51822 eval board and I am just trying to download the blinky project. I have followed the quick start instructions in the nrf51822 user guide but every time...
Hi
In Desktop 2 v1.0.4, did you consider the debounce as keyboard buttons were pressed or released?
How long is the debounce confirming time? Thanks.
Jeffery
Hi, my name is nils. I am trying to develop on the nrf51822 eval board. I use eclipse an gcc with the j-link under windows 7 to programm/compile/and flash. I got it to work...
Hello,
We are working in the field of Electric Bike Propulsion Systems.
We want our motor to be able to communicate to I-phone/Android phone on Bluetooth.
We are searching...
Hello Nordic experts,
I can find current consumption in standby mode data from nRF24L01plus datasheet.
But it seems standby mode current consumption is not mentioned in...
We would like to be able to communicate with an nRF51422 target system from a Windows host. (for target signal processing algorithm debugging ).
Our previous system used...
how can I program SPI to select more than only one slave device with any GPIO ?
SPI Routine "spi_master_int" can select SPI0 or SPI1 only with one dedicated GPIO as Slave...
I want to know the EXT interrupt (GPINT1 & GPINT0) can use at the same time. When I use the GPINT1 & GPINT0 at the same time,only one is OK the other is faile.
I'm looking at the led.c example in the heart rate monitor example. What this shows is how to tie a TIMER event to toggling an LED. I understand most of the mechanism there...
We are building custom hardware with nRF51422 and need to program the softdevice in order to get the ANT stack running in the chips which I suppose is not flashed with S210...
Please provide recommendations (Supplier & Part Number) for chip antennas that have been used successfully in actual released FCC/ETSI certified Nordic-based product designs...
