Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
hello,
my custom hardware includes 10 buttons connected to 10 GPIOs of a nRF52832. The nRF52 is placed in low power or eventually system OFF all the time, waiting for a...
hello i am using the nrf52840.
how i can set the 4Khz frequency in low_power_pwm.
low_power_pwm_config_t have period parameters. which value i need to assign to generate...
Hello,
I am trying to migrate to the latest S140 SoftDevice, but the migration document leaves a lot to be desired and is missing information. I've had issues running standard...
Hi
I'm migrating to SDK14 currently. My program seems to hit an infinite loop (or something of the sort) after I call my_service_on_connect() from my_service_on_ble_evt...
Hi all,
I have a custom board with a nRF51 and a DSP connected to eachother (SPI, UART and I2C) and since I have no connection to the nRF directly or any buttons I need...
I want to change the light-control example given in mesh SDK such that instead of using buttons to trigger messages, I want to connect client with mobile and control servers...
Hi, I am working with app_uart module and during the reception process sometimes there will be APP_UART_COMMUNICATION_ERROR event generated, my question is why there is such...
Hi,
I am testing with ble_app_uart code for handling UART data. If the data is more the device is getting disconnected from the central device. I am thinking that, BLE...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
I have the test that spi communication between nRF51 DK(Master) and nRF52 DK (Slave).
use the example projects in SDK 12.2.
success build and writing but i have got...
I would like to utilize six Sampo S1 readers (yes, I only read for now, I know they can do much more) to count people entering and leaving a conference.
I am looking for...
I implement it with sdk 11.0 and a third party board.Firstly,I program s132_nrf52_2.0.1 SoftDevice by nRFgo Studio，secondly，i program dfu_dual_bank_ble_s132_pca10036. then...
