Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
I have been having issues with our Flash component ( S25FL256S ) over SPI with the nRF52832 using easyDMA. When reading out values of a peripheral, the returned contents are...
Hello,
I am working on the project as CDC Example.
When I make CDC communication with the nRF52840 in my Windows Tool,
We confirmed that communication was not possible...
hi,
My program used total 10 app_timers, like this APP_TIMER_DEF(connect_timer_id); APP_TIMER_DEF(scan_timer_id); APP_TIMER_DEF(standby_timer_id);
I don't know how to...
Am currently using Apache Mynewt.
BLE Mesh works great when utilising the provided samples.
However, because of lack of documentation / my lack of knowledge am unable...
I'am using notify continues to send large amounts of data,i want to know that notify whether can guarantee package serial number not random sequence and ensure that each data...
Once the Nexus 7 wakes up from deep sleep, we are unable to get scanned devices on Nexus 7.
Turning off the Bluetooth and turning it on again does show the devices. Is...
For DFU and BLE application coexistence, Can I add application services into BOOTLOAD for routine BLE application with DFU? instead of the way that reset from BLE application...
Hello I would like to know when nrf51822 (SDK v12.3 with SD S130 ) advertising timeout and system goes to sleep , how could I retain the ram data so the MCU could work properly...
Dear experts,
I'm using nrf52832 with softdevice s132 v2 for BLE central products developing. According to the specification of s132 v2: We should run some code to get...
Hi. I'm using nRF52832, SDK13.0.0 as peripheral.
My peripheral is advertising every 400msec and it has advdata and rspdata.
As I know, right after a central sends scan...
Hi,
we are using nRF51822 for one of our application.
We are trying to get the public MAC ID of the device itself. Please suggest how can we do so from the application...
Hi,
I am using NRF Sniffer firmware 1.0.1 but I need to reduce the baud rate to 115200
Is there any way I can do this?
Does it supports changing baudrate?
