Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
I am working on a ZigBee coordinator device that will collect data from various sensors in the network and forward them to a gateway. I have started with the CLI example and...
We have custom board based on nrf52840 and using an application based Zephyr RTOS platform.
Sometimes, it is observed bus fault and hardware exception logs are observed...
Hello,
I am really wondering about the design of the UARTE peripheral. The documentation for the nrf_drv_uart and the nrf_serial library is lacking quite a bit. Most of...
Dear Nordic:
My NRF51822 based SDK9.0 can not connect HuaWei mate30 mobile,but it can work for any other mobile with android system.I used nRF master pannel APP downloaded...
Hi!
I'm having trouble getting any response from an NRF52840 MCU on a custom board we've made.
I'm hoping someone will be able to point me in the right direction by detailing...
I'm using pc-ble-driver(C program) to get the data from other device, I can get character now, but I don't know how to turn on the character's notification like the start...
We wanted to implement both BLE and serial DFU on nRF52832 without serial flow control. The main procedure is as follows:
Use the Nordic BLE DFU example as a start...
Hello,
I am using nRF52840, SDK_16.0.0, S140 SoftDevice and Segger 4.16 for flashing the image. I am using ‘ble_app_blinky’.
I have queries on enabling HW crpto accelerator...
I'm implementing the device side of the DFU-protocol (v16) (Control Point & Packet) using the nFR Connect Mobile as DFU Controller. In the app I select Application as file...
Hi All,
Since 2 weeks I try to configure a gap with a "raw payload" but it's a Chinese puzzle! Between different SDK, with different "Soft Devices" and examples dating back...
Hi,
I've install the throughput example (examples/ble_central_and_peripheral/experimental/ble_app_att_mtu_throughput) on an nRF52840-DK and I test it against all kind of...
