Hello, I’m testing a PID controller for a quadcopter. When I compile the application with the optimize for speed then flash, I notice that the PID response is slower than...
Hi,
I have a couple of questions regarding reading the nRF5340 Temperature Sensor. This is a follow-up to the following DevZone ticket: https://devzone.nordicsemi.com/f...
Hi.
I wonder if you could help me:
I'm using a thingy91x and would like to work with the npm1300. In the case of this hardware, the PMIC npm1300's i2c bus is connected...
RTT log output issue
Hello, I am using SDK v3.0.2 and toolchain v3.0.2. After building and flashing my firmware, no logs are being output to RTT Viewer. What should I do...
We tested the USB performance on the v3.1.0-preview4 and main it looks like it got even worse.
All tests were done on the attached test project: TestProject
main (6855b38ca69d2a70d0a088d9964e606e9981cb14...
Hi all!
I have the NRF54H20 D and somehow the RTT viewer doesn’t work, the board doesn’t work. I am using the most simple zephyr hello world project. It says it is compatible...
Hi there,
We are using for BLE communication a nRF52832 chip with random static address configuration (shown in the UART). Can we be sure that the address of a chip will...
Greetings all -
We have an nrf51-dongle for development and testing purposes, and are unable to connect to the device over USB with any of the Segger or Nordic tools. I...
Due to BLE's low range, license costs and unneeded complexity, I am looking in to pure radio RF. I am curious about ESB and Gazelle, and which one is good for relatively simple...
Testing OTA using nRF Toolbox on Android. Everything works fine, but for some reason the file selection is "stuck" in dropbox, i.e. I can not go up a level from dropbox, and...
my development environment is nRF-DK and IOT SDK
Q1 : IOT SDK Support Gatt Profile?
Q2 : IoT SDK Support DFU mode?
Q3 : in ipv6 coap server example, how i broadcast...
Hi!
I have custom board with nRF51822 and I need to communicate with serial flash W25X40 using SPI master example with SoftDevice enabled (S110 is used). I worked with...
Hello Everyone
i am using LINK LOSS service i would like to send notifcation to the peer device if the connection is lost and also if the connection is made between two...
Hi,
How to send large amount of data, using multiple characteristics? Assume that my data size 800 bytes and characteristics with notify property. I did splitting the data...
Hello,
I am looking for a way to send more than 20 bytes by using 'sd_ble_gatts_hvx' function.
I want to get the maximum debit that is in theory 6x20 bytes
Do I just...
Hello everyone,
I am doing a project in which a nRF58122 is getting data of an accelerometer and an ADC. Those can be set a really high frequencies. The problem is, when...
Hi all,
I'm working with the Nordic nRF51422 DK that has the nRF51422 chip with 32 KB of RAM.
My application works great on it using the SoftDevice S130 as BLE stack....
Hello!
I have been experiencing some trouble with the PStorage API. I have browsed every example and similar question I can find and none seem to match the continuing issues...
