Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
i made this project to try to create RSC service on arduino
developer.bluetooth.org/.../runningspeedandcadence.zip
unfortunately the server starts but i'm not able to...
Hello,
Could someone give me a hint with the following problem?
I am using two example projects (ble_app_uart_c, ble_app_hrs) to connect a central and a peripheral.
An...
Hi, I am working with app_uart module and during the reception process sometimes there will be APP_UART_COMMUNICATION_ERROR event generated, my question is why there is such...
Hi,
I am testing with ble_app_uart code for handling UART data. If the data is more the device is getting disconnected from the central device. I am thinking that, BLE...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
I have the test that spi communication between nRF51 DK(Master) and nRF52 DK (Slave).
use the example projects in SDK 12.2.
success build and writing but i have got...
I would like to utilize six Sampo S1 readers (yes, I only read for now, I know they can do much more) to count people entering and leaving a conference.
I am looking for...
I implement it with sdk 11.0 and a third party board.Firstly,I program s132_nrf52_2.0.1 SoftDevice by nRFgo Studio，secondly，i program dfu_dual_bank_ble_s132_pca10036. then...
Hi experts
I am trying to interface an external ADC to NRF51-DK i am presently reading SPI ADC code values on BUTTON press event. I am able to read the values from ADC...
Post in reference to link
After flashing light control server or client app on PCA10028 app crashes with HARD FAULT.
Steps how I built the app:
Using freshly downloaded...
Hello,
I find that some examples such as ble_app_uart uses a GATT_MAX_MTU_SIZE of 158, and it has initialization in function ble_stack_init().
// Configure the maximum...
Hi. I'm using nRF52832. I need more GPIOs and UARTs. So I think nRF52840 is very good solution to me.
But as I know, nRF52840 is just engineering sample now.
When can...
I am running the Iot SDK Cloud MQTT example on a nrf52 DK. Is there are reason why MQTT will only let me subscribe to a maximum of 9 topics. Anymore and some of the topics...
I'd like to get the current connection state eg:
result = get_connection_state()
if(result == BLE_GAP_EVT_CONNECTED)
doSomthing();
Is there such a function available...
