Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
I am using mbed library to get leg up on development.
This is the first time I am writing any MCU application and it sure makes things a lot easier.
I am using nRF51822...
I've recently began experimenting with the HID service and connecting to iOS devices in order to achieve lower connection intervals with Apple products (as described in their...
some questions for power consumption of 52840.
We've planned to use about 10 to 30 nRF52840 devices for advertising TX mode. One scan mode device which is connected with...
I have a device based on the Nordic nRF52832. I am using softdevice s132. I am using Nordic nRF5_SDK_15.3.0_59ac345. My Android device I am testing with is running Android...
I recently bought a reel of nRF52840 and received rev C0 (Which is Engineering C). We require long range in our solution (Coded PHY). I was reading the compatibility matrix...
Hello,
I'm trying to stream data at ~ 30KB/s rate. I use nRF52840 development board with S140 as peripherial and smartphone with "nRF Connect" app as central. UART example...
Hello, Nordic.
A while ago, debug terminal do not appear in Segger Embedded Studio, and nothing happens when I click View -> debug terminal in the tab bar.
Currently...
As far as I understand, the nRF52840 USB dongle can be flashed via USB if there's a DFU capable bootloader installed (and it booted *into* that mode).
Once I got the dongle...
Hi
Good day!
I am new to this BLE module. I have worked out an application using nrf52 DK (nrf52832 SoC ) and now I want to use Ebyte module E73-2G4M04S1B which is based...
Hi team,
I am using nRF5_SDK_15.3.0_59ac345 and nrf52832 controller. I am using nRF5_SDK_15.3.0_59ac345/examples/ble_peripheral/ble_app_uart example code and the hardware...
Hello,
Please check my schematics with PA / LNA.
I have problems activating PA / LNA, the connection is very difficult when using the battery, I am forced to use external...
Hello,
Every time I try to run any example I download online for my nrf52832 board I get dependencies errors after locating the project folder to the sub "examples" folder...
I am trying to get battery % from the thingy91. I have the AT command AT%XVBAT running successfully. It returns what I assume is millivolts. However these value are higher...
When testing different applications on an nRF52840 dongle I have the following problem: The table of service and characteristics (1 service and 4 characteristics) of an earlier...
