Hi,
I have two nearly identical revisions of a board with an nrf5340 which behave differently in a curious way:
On one revision I can issue a "mon reset" command in...
Hey Team,
I'm trying to flash the audio application on our custom PCB, this PCB follows the interfaces of the nrf5340 audio dk. Previously on lower SDK versions (2.7-2.9...
Hi Nordic team,
This is a follow-up to my previous question here:
Can nRF52833 perform PAwR while also syncing to another PAwR device?
We are now extending our design...
Hi,
I'm trying to build nmea parser, so I have a functionc hecking all nmea sentences and trying to get double value, but I always go bad double value. For example here...
Hi
I am trying to setup and test the OpenThread CSL feature on nrf52840DK with OpenThread daemon and RCP mode nrf52840DK.
I found there is a way to build the Daemon for...
Hi,
With several nrf52840 based prototypes, I had serious problems. I could see them die after flasing them a few times. And this was not just one dying, it was all of them...
Is a common ground required when measuring current in current meter way?
Can externally supplied voltage exceed 5V? Will this cause inaccurate test results?
Hello all
I'm struggling with link errors, "undefined referencce atan2" as well as all math library.
I still dont know why it is occurred these errors.
I configured the...
Hi,
I'm trying to move my code from Red Bear BLE shield with Arduino to nRF51 dongle.
Is there any possible method?
(ex. share the same library or SDK helping)
I just read the S13x migration guide .. have some work to do :(. I'll have to read it a few more times to get my head around the bandwidth configuration but it looks super...
Hello, I started with NRF24L01 + Arduino and that works fine for me. Then I saw the nrf24LE1 and I thought that would be smaller and cheaper. I ordered the NRF24LE1 development...
Hello Everyone,
I was taking a look at the PCB in Ditto . It uses an nRF51822 and supports firmware updates from their app which means they put a bootloader on it.
I've...
hello guys,
I'm working in a project & I'm debugging using nrf15822a development kit, I want to implement the DFU & security feature to have a secured link and to be able...
Hi guys..
I try to figure out how to connect nrf 51df , raspberry pi (ble enabled router), COAP client which is on the external network. Trying to figure out it, I found...
I noticed the following compile time issue in the SDK - both 10 and 11:
The file ./examples/ble_central/ble_app_hrs_c/main.c
needs:
#include "app_uart.h"
For...
Hi,
Could anyone give some advice how can I let 51822 works in RFID mode.
Can RFID work together with BLE? Or is there anoter HAL support like Softdevice? Where can...
Interrupt_Sleep.txt
Currently, I'm trying to use external interrupt that generated by ADXL345 to wake up the nrf51822 after sleep but not working as i want. Kindly check...
I'm had develloped some software and tested it on the nRF51-DK.
After that I made my own PCB design where only the nRF51422 is replaced by a nRF51822.
When I flash both...
