At some point in the past I had nrf51+gdb+breakpoints working just fine. I even have a bunch of __BKPT() calls in my various error handlers to trap into the debugger.
At...
Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
now, i have a question: i have a buffer 100byte data to send, when i send data package via sd_ble_hvx() continus,delay 20ms after each send ,but it will lost some data , i...
HEllo,
I am facing and issue with undefined references for the linker. The compiler is able to compile, but I get linker errors like these
.../pca10040/s132/arm4...
Hello everyone, I recently use the nRF51822 with SD9 and S110, I found that the device name was define as: #define BLE_GAP_DEVNAME_MAX_LEN 31
is it means the max length of...
Hello!
We have built an app that transfers files from an app on Android to the device running an nRF52 with S132. On the device is an external flash using SPIFFS as a file...
Hi to everybody,
I am working with nrf52 and SDK11. In my project I am using freertos and an UARTE with this configuration:
9600bps
TX/RX (no CTS; no RTS)
HW...
Hi All,
We are interfacing Nordic nRF52832 with our Display using SPI interface. As per display, Data / Command bit needs to be set at the beginning of transfer. Using...
I am trying to understand the use of multiple channels in the timer. Looks like the use of the multiple channels is for PWM/ sequencing type applications. It is not intended...
I am using nrf51822 and having some questions,as follow:
1、the pin reset is common with the pin SWDIO(the debug IO pin).when I download into nrf51822 using JLINK（setting...
I am working on a nRF52328 present in the Taiyo Yuden EYSHJNZXZ module. I am using a J-link EDU debugger to program it. Can I use the J-Link for UART communication with the...
I am developing an application in which my device will have multiple android phones connected to it. Currently I have it working with one peripheral and after having upgraded...
Dear all,
I am working on one sensor project(temp and accelerometer sensors) where our Nordic nrf51822 soc should read the data using spi protocol and transfer it to the...
